BEAD WIRE MANUFACTURING

Entangling wire switch consists of a ring of large diameter fixed on spindle, ring and spindle are joined to the cover perpendicularly. In operation rod passes freely through the ring. However, if the rod is entangled it falls from the unwinding rod support, which makes the ring and spindle move forward, turn off the limit switch, located on the cover, and immediately stop the drawing machine setting the line in motion, in order to avoid wire breakage.

• Water is fed into the upper working reservoir via circulation pump arranged to jet direction, water supplied to the upper working reservoir, pours back into the circulation reservoir.
• Gas purification system is installed at the outlet of the reservoir body, it prevents water drops on wires entering the reservoirs of the next processing stage. Gas resource used for gas cleaning, is a stream of medium pressure provided by the Customer (the same way).

2 sets, one set - the circulation pump with corrosion-resistant coating, a second set - plate heat exchanger, it is possible to cool the acid solution, the temperature is displayed in digital form, there is an ability of automatic adjustment.

The reservoir is designed for complete electrolysis acid etching, providing physical and chemical reaction on the wire surface in the electrolytic solution, as well as providing power control of physical and chemical reactions by adjusting the concentration, composition, temperature, current, time and polarity to achieve the removal of oxidation layer from the wire surface.

• Upper working tank is installed with a lead plate inside. The polarity of the lead plate for each group of the working tank is arranged as follows: ++ - ++ reservoir is fully equipped with 3 groups of upper working tank.
• Gas purification system is installed at the outlet of the tank body, preventing water drops on wires entering the reservoirs of the next processing stage.
• Extract hood is mounted on the tank body, behind the mating flange of the extract hood exit section the Customer will provide a connection to equipment for processing or diversion.

• Pure water is added to the third block of the storage reservoir, third block rinsing is performed by means of circulating pump jet rinsing.
• After rinsing water is poured into the second block of the storage reservoir again, at the same time the second block rinsing takes place by means of circulating pump jet rinsing and so on. Then after rinsing water is drained.
• Gas purification system is installed at the outlet of the tank body, preventing water drops on wires entering the reservoirs of the next processing stage.

• The reservoir is equipped with a steam heater inside.
• Heat-insulating wool is used for heat conservation around the tank, preventing heat dissipation.
• On top of the tank there is a hinged cover, convenient to use.
• Gas purification system is installed at the outlet of the tank body, preventing water drops on wires entering the reservoirs of the next processing stage.

• Bath is equipped with a steam heater inside.
• Heat-insulating wool is used for heat conservation around the tank, preventing heat dissipation.
• On top of the tank there is a hinged cover, convenient to use.
• Gas purification system is installed at the outlet of the tank body, preventing water drops on wires entering the reservoirs of the next processing stage.

• Each wired is equipped with two Ø320 mm guide pulleys separating wires, which are installed behind for the drying tank and in front of the drawing machine.
• Guide pulleys for wire separation located in front of the drawing machine must be at the same level with the first drawing channel of the drawing machine.